Zoom ADSL Modem BRIDGE 5515 - Manual (Page 25)

Appendix C: Custom Installation Instructions 25
Tip: If the Network Password box doesn’t display, perform
the following in this order:
a a a a Recheck all connections.
b b b b Restart the modem and computer.
cccc Perform a “hard” reset. (See page 11.)
2 2 2 2 The Basic Setup page displays. You are now communicating
with your Bridge.
a a a a Change the VPI and VCI numbers so that they match
those given by your service provider.
b b b b Click Save Changes and Write Settings to Flash and
Reboot. Once the reboot is complete and the unit has
reset itself—when the front panel’s LINK light remains
on steady again—close the Zoom Web Console page.
cccc Continue below with Completing the Installation.
REMEMBER:
Any time you make a change to the Basic Setup page, you
must click the Save Changes button and then the Write
Settings to Flash and Reboot button. A Confirm page
displays; click the button to complete the process. If not, the
change will be lost when you navigate to another page.
Completing the Installation
To complete the Bridge setup, you need to re-adjust your IP
address, depending on your service provider.