Well Traveled Living FirrSense Urn - Manual (Page 4)

Assembly Instructions
5 Place Bowl, Wood Grid, Spark Guard
Lighting
1. Make sure there is only a small amount of ash in the bottom of the bowl.
2. Place a layer of dry kindling or a natural firestarter onto the center of the grate.
3. Place above that a layer of dry seasoned hardwood that is cut to lengths no more than
3/4 the diameter of the bowl.
4. Use a match to light kindling or firestarter.
5. Using a hook and heat resistant gloves, replace spark guard once the kindling or firestarter is
lit.
Tending the Fire
You may need to shift and/or add logs for an ideal experience.
CAUTION: Do NOT place a hot spark guard or hot firebowl tools onto
combustible surfaces such as grass, wooden deck or furniture.
1. Using a hook and heat resistant gloves, carefully remove spark guard.
2. While using a long handled fire pit tool, shift coals and logs to allow additional airflow.
3. Do NOT add gasoline, kerosene, diesel fuel, lighter fluid or alcohol to relight or enhance an
existing fire.
4. Wait until glowing coals have developed before adding any additional wood. If additional
wood is required, place wood on top coals. Be careful not to shift ashes.
5. Using a hook and heat resistant gloves, replace spark guard.
Extinguishing
1. Allow fire to burn itself out.
2. Do NOT use water to extinguish as this is dangerous and can cause damage to this outdoor
fire pit.
Cleaning and Care
Inspecting
This outdoor fire pit should be inspected on a regular basis to ensure product safety and
longer product life.
CAUTION: Do NOT attempt to inspect this outdoor fire pit until the fire
is COMPLETELY out.
1. Check handles to make sure they are secure.
2. Check components for any signs of damage or rust.
3. If damage to any component is detected, do NOT operate until repairs are executed.
Cleaning
This outdoor firebowl should be cleaned on a regular basis to promote safer experiences and
longer product life.
Note: After repeated use, a slight discoloration of the finish may occur.
CAUTION: Do NOT attempt to clean this outdoor fire pit until the fire is
COMPLETELY out.
CAUTION: Do NOT use oven cleaner or abrasive cleaners as they will
damage this product.
CAUTION: Do NOT clean any part of this outdoor fire pit in a self
cleaning oven as it may damage the finish.
1. Wipe exterior surfaces with a mild dishwashing detergent or baking soda.
2. For stubborn surfaces use a citrus based degreaser and a nylon scrubbing brush.
3. Rinse clean with water.
4. Remove built-up creosote from components with a chimney cleaning product.
Storage
CAUTION: Do NOT move or store this outdoor fire pit until the fire is
COMPLETELY out.
1. Once the fire is out, coals are cold and outdoor fire pit is cool to the touch, remove ashes
and properly dispose.
2. Store assembled in a location away from children and pets.
Operating Instructions
4