Woods Equipment 7000 - Manual (Page 28)

26 Dealer Service
MAN0137 (9/14/01)
DEALER SERVICE
Cont’d
NOTES
Install Drive Pulley
1. Install drive pulley (19) with split taper bushing
(12) on gearbox vertical shaft. Make sure key (82)
and keyways are aligned.
2. Position center line of drive pulley (19) 15/16"
(plus or minus 1/32") above mounting surface of gear-
box stand (20) as shown. This is a very critical
dimension and must be held.
3. Alternately tighten split taper bushing set screws
to 14 lbs.-ft. Check mounting distance to make sure it
is correct.
Figure 20 Drive Pulley Dimensions
20
19
82 12
1-7/8"
15/16"
DB2938