beautypg.com

Appendix, Display screen messages – VTech CS6124-2 User Manual

Page 35

background image

31

Appendix

Annc deleted

Your recorded announcement is deleted.

Call log empty

There are no call log entries.

Directory empty

There are no directory entries.

Directory full

The directory is full.

Ended X:XX:XX

You have just ended a call.

Incoming call

There is an incoming call.

Line in use

A system handset or another telephone on the same line is in use.

Low battery

The battery needs to be recharged.

Microphone on

MUTE is turned off and the person on the other end can hear you.

Muted

You have turned off the handset microphone. The other party cannot

hear you but you can hear the other party.

New voicemail

There are new voicemail message(s) from the telephone service provider.

No battery

No battery is installed. Follow the directions for battery installation on

page 3 to install the battery before charging.

No line

There is no telephone line connected.

No message

There are no messages in the answering system.

Not available

One handset is reviewing the call log and the other handset tries to

review it; or one handset is accessing the answering system and the

other handset tries to access it.

Not registered

The handset may be deregistered from the telephone base. Follow the

instructions on page 34 to register the handset to the telephone base.

Number repeated

The telephone number entered is already stored in the directory.

Out of range or
no pwr at base

The handset cannot communicate with the telephone base. Check the

telephone base power connection or move the handset closer to the

telephone base.

Phone X:XX:XX

The handset is on a call.

Place in charger

The battery is very low. Place the handset in the telephone base or

charger for recharging.

Rec mem full

The answering system has no recording time left.

Record in X sec

You can record your own announcement or memo after the tone

is played.

Ringer muted

The handset ringer is muted temporarily during an incoming call.

Ringer off

The handset ringer is turned off.

Saved

Your selection has been saved.

Try again

Communication between the handset and the telephone base is lost

during a call.

XX missed calls

There are calls that have not been reviewed in the call log.

XX new messages

There are new messages in the answering system.

** Paging **

All system handsets are being paged.

Display screen messages

Appendix

This manual is related to the following products: