VTech IP 811 - Manual (Page 8)

Getting Started
Registration
Your IP 811 is an accessory handsets for use with the IP 8100-2/8100-3 base unit. To
register your IP 811 for the first time:
1. After charging the battery, the screen will display:
.
7
S E A R C H I N G . . .
ENTER BASE ID
###############
HANDSET X
2. Enter the 15 digit base unit ID code, located on the
underside of your
IP 8100-2/8100-3 base. If you
make a mistake, press the DELETE key to
backspace (delete characters), then enter the
correct information.
3. Press SEL to complete the registration process.
4. Once a valid base ID code has been entered, the
display will blank for a second or two, and then
show:
5. If the base accepts the new handset, after several
seconds the new handset will show:
Where X is the new handset number assigned,
sequentially, by the base.
NOTE: If any of the digits are entered incorrectly press the DELETE key to erase
a character(s) and carefully re-enter the correct base ID code. If you have
entered any digits incorrectly you will hear an error tone after the SEL key is
pressed. The 15-digit base ID code may contain numbers and characters, in-
cluding 0 through 9 and *. Make sure you enter all 15 digits.