Uniden 1380 - Manual (Page 17)

17
Setting the Security Code
This feature allows you to change the factory default remote access code used
for remote access to your answerer. The default code is 123.
1. Press and release the
MENU button until the screen displays REMOTE
ACCESS.
2. The left-most digit, or a (_) sign flashes indicating the unit is ready to accept
the security code entry.
3. Use the keypad number to set the 3-digit security code in one step.
4. After the 3rd and last digit is entered, press the
MENU button to store the
security code and go to the next setting.
Note: To skip to the next setting, press MENU. To exit setup, press
EXIT.
Note: If you make a mistake, you can use SKIP or REPEAT to move
between 1st to 3rd digit and input number from keypad again.
Setting the Display Contrast
This setting allows you to adjust the display contrast for easier readability.
1. Press and release the
MENU button until the screen displays CONTRAST.
2. Use SKIP or REPEAT to select the desired setting (1-5).
3. When finished, press MENU to confirm and go to the next setting.
Note: To skip to the next setting, press MENU. To exit setup, press EXIT.