Perreaux SILHOUETTE SXD2 - Manual (Page 19)

18
7 7 7 7 Care and Maintenance
Note: Please switch the unit off and remove the cord set from the
rear of the USB DAC before attempting to clean your SXD2
in the manner described below.
Never apply liquid directly to the SXD2.
Never use abrasives.
Never rub in a circular motion.
Cover The cover features a durable high quality powder coat finish. To
remove finger marks and dirt, lightly rub the surface with a soft
cloth.
If the dirt is not removed, dip your cloth in a mild solution of
soap and water, squeeze excess moisture from it and then gently
reapply to the surface.
Stubborn dirt may be removed by the application of a small
quantity of isopropyl alcohol, applied directly to the cleaning
cloth only, and reworking the effected area.
Front Panel The SXD2 front panel features a high quality electroplate finish.
Over time the surface may retain finger marks and may need to
be cleaned to restore it to original condition.
Regular Cleaning
Gently wipe the front panel with a very clean cotton cloth. Wipe
across the surface and never in a circular motion.
Removing Stubborn Marks
Only attempt this infrequently, as too regular or vigorous
application may damage the surface.
Apply a small quantity of any car polish containing carnauba
wax to a very clean cotton cloth.
Note: The car polish must state “Safe for Clear Coats” as the polish
will therefore contain the absolute minimum amount of
abrasive compound.
Gently wipe over the front panel in lateral motion, allow to dry
then gently wipe off with a very clean cotton cloth.