RCA L46FHD37R - Manual (Page 7)

Removing the Table Stand
Your TV comes with the table stand attached. If you want to mount your TV to the wall, remove the table stand
by following the instructions below.
Step 1
Place the plastic bag off the TV and place it on a
table or other flat surface. Place the TV set face
down on the TV bag.
Step 3 (Only for model L42FHD37R/L46FHD37R)
Attach the stand cap to the TV cabinet.
TV cabinet with stand cap attached.
Connections and Setup Chapter 1
7
Step 2
Remove the table stand from the TV cabinet. Use a
screwdriver to remove the three M6 ST-screws.(Note: For
model L46FHD37R, there are four M5 ST-screws. )
1
Mounting Your TV to the Wall
The VESA number is the horizontal and vertical measurement of the mounting holes. For example, 600x400
refers to fact that the mounting measurements are 600mm horizontally and 400mm vertically.
Follow the directions included with the wall mount to mount the TV to the wall.
Caution: Your wall
mount must be able to
bear a minimum of five
times the TV’s net
weight to avoid causing
damage.
To mount your TV to the wall, purchase a VESA wall
Models L40FHD41/L42FHD37R/L46FHD37R Purchase a VESA 600 x400, Size M6 screw
Step 3 (Only for model L40FHD41)
Attach the stand cap to the TV cabinet using a M4
ST-screw and a screwdriver.
TV cabinet with stand cap attached.