NISSAN VERSA 2009 - Manual (Page 6)

WINDSHIELD WIPER/WASHER SWITCH
Ⅲ The ignition switch must be in the ON position to
activate the windshield wipers.
Ⅲ Move the lever to the following positions to oper-
ate the windshield wipers:
Intermittent (INT) – Front wipers operate
intermittently and can be further adjusted by
twisting the time control ring .
Low Speed (LO) – Continuous low-speed
operation of front wipers.
High Speed (HI) – Continuous high-speed
operation of front wipers.
Mist (MIST) – Lift the lever up for one sweep of the front wipers.
Rear Wiper (REAR) (if so equipped) – Twist the end section to operate the first
(INT) or second (ON) speed settings for the rear wipers.
Ⅲ Pull the lever toward you to activate front washer fluid and several sweeps of the wipers.
HEADLIGHT AND TURN SIGNAL CONTROL
HEADLIGHT CONTROL SWITCH
Ⅲ Turn the headlight control switch
to the
position to turn on the front parking, tail, license plate
and instrument panel lights.
Ⅲ Turn the headlight control switch
to the po-
sition to turn on the headlights. All other lights remain
on.
FOG LIGHT OPERATION (if so equipped)
NOTE: The headlights must be on and the low beams selected for the fog lights to operate.
Ⅲ Turn the switch (inside collar)
to the position to turn on the fog lights.
Ⅲ Turn the switch (inside collar)
to the OFF position to turn off the fog lights.
HIGH BEAM
Ⅲ Push the headlight control switch forward
to se-
lect the high beam function. The blue indicator
light illuminates. Pull the headlight switch back to the
original position to select the low beam. The blue
indicator light goes off.
4