Nostalgia Electrics KRS-2150 - Manual (Page 12)

ENGLISH
10
CO2 & TAP TOWER INSTALLATION
You must read and understand the steps below for the CO2 assembly before
installation. When you purchase the first keg of beer, you must also have your
CO2 cylinder filled at your local supplier. CO2 tanks can be refilled at locations
such as welding supply shops, party stores, or wherever kegs are purchased.
(cont. on next page)
STEP 1
Make sure white nylon High Pressure
Washer (already installed) is attached
to CO2 Double Regulator.
STEP 2
Use Wrench to attach Double
Regulator to CO2 Tank connector.
STEP 3
Remove spring from inside the
Keg Coupler. If spring is not
present, go on to
Step 4.
STEP 4
Make sure Backflow Stopper
is insterted in the Keg Coupler
(the Backflow Stopper goes in
with rounded side down).
STEP 5
After the Backflow Stopper has been
inserted, remove the three parts above.