Nilfisk-Advance America 56262214 - Manual (Page 2)

2 - FORM NO. 56041590 / AX 300 / AX 400
Table of Contents
Page
Introduction ........................................................................ 2
Parts and Service .............................................................. 2
Nameplate ......................................................................... 2
Unpacking the Machine ..................................................... 2
Important Safety Instructions ............................................. 3
Importantes mesures de sécurité ...................................... 4
Preparing the Machine for Use .................................... 5-8
Installing the Brush ............................................................ 5
For Use on Carpeted Floors .............................................. 6
For Use on Hard Floors ..................................................... 7
Filling the Solution Tank .................................................... 8
Operation ...................................................................... 9-10
After Use ......................................................................... 11
Maintenance .............................................................. 12-13
Maintenance Schedule .................................................... 12
Storing the Machine......................................................... 12
Brush Maintenance.......................................................... 12
Pick-Up Tool Maintenance .............................................. 12
Power Cord Maintenance ................................................ 12
Spray Nozzle Maintenance .............................................. 12
Lubrication ....................................................................... 13
Vacuum Motor Maintenance ............................................ 13
Optional Accessories .................................................... 14
Hard Floor Kits ................................................................ 14
Brush Options .................................................................. 14
Optional Accessory Tools ................................................ 14
Technical specifications ................................................... 14
For UK and Ireland only:
IMPORTANT!
THE PLUG IS NOT WATERPROOF - KEEP DRY
The cord is already fitted with a molded plug incorporating a fuse, the value of which is indicated on the pin face of the
plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the same rating marked
thus "10A". If the fuse cover is detachable, never use the plug with the cover omitted. If a replacement fuse cover is
required, ensure it is of the same color as that visible on the pin face of the plug (i.e. red or orange). Fuse covers are
available from the Parts Department indicated on the last page. If the plug supplied is not suitable for your socket outlet,
it should be cut off and destroyed. The end of the flexible cord should be suitably prepared and the correct plug fitted.
The wires in the main lead are colored in accordance with the following code: Blue - Neutral, Brown - Live. As these colors
may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: The wire which
is colored Blue must be connected to the terminal in the plug which is marked with the letter N or colored Blue or Black.
The wire which is colored Brown must be connected to the terminal which is marked with the letter L, or colored Brown
or Red.
WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE LETTER
E, BY THE EARTH SYMBOL OR COLORED GREEN OR GREEN/YELLOW.
*WARNING: A PLUG WITH BARED FLEXIBLE CORDS IS HAZARDOUS IF ENGAGED IN A LIVE SOCKET OUTLET.
INTRODUCTION
This manual will help you get the most from your Nilfisk AX 300/
400. Read it thoroughly before operating the machine.
This product is intended for commercial use only.
PARTS AND SERVICE
Repairs, when required, should be performed by Nilfisk service
personnel using Nilfisk original replacement parts and accessories.
Call Nilfisk for repair parts or service. Please specify the Model and
Serial Number when discussing your machine.
NAME PLATE
The Model and Serial Number of your machine are shown on the
Nameplate on the back panel of the machine. This information is
needed when ordering repair parts for the machine. Use the space
below to note the Model and Serial Number of your machine for
future reference.
MODEL
SERIAL NUMBER
UNPACKING THE MACHINE
When the machine is delivered, carefully inspect the shipping
carton and the machine for damage. If damage is evident, save the
shipping carton so that it can be inspected by the carrier that
delivered it. Contact the carrier immediately to file a freight
damage claim.