Nilfisk-Advance America SR 1800S 2WD - Manual (Page 72)

ENGLISH USER MANUAL
18 33014097(2)2006-12 A SR 1800S D 2WD
Maintenance
Running-in period
(after the fi rst 24
hours)
Every 10 hours
or before use
Every
200
hours
Every
600
hours
Every
1,200
hours
Every
2,400
hours
Long
periods
Fuel fi lter replacement (7)
Nut and screw tightening and
leakage check
(6) (6)
Lubrication (6)
Engine coolant line sleeve check (7)(6)
Drive system pump oil fi lter
check
(6) (6)
Hydraulic system oil suction fi lter
replacement
(6) (6)
Alternator belt replacement (3)(6)
Cab air fi lter replacement (1)
Injector calibration and cleaning (2)(3)(6)
Climate control system belt
replacement
(6)
Engine coolant replacement (3)(6)
Hydraulic system oil change (3)(6)
Brake system check (6)
Hydraulic system pump pressure
check
(6)
Minor engine overhaul (2)(4)(6)
Major engine overhaul (2)(5)(6)
(1): Or every 6 months
(2): Maintenance to be performed by Lombardini authorised Service Center
(3): Or every 2 years
(4): After 5,000 hours
(5): After 10,000 hours
(6): For the relevant procedure see the Service Manual, at any Nilfi sk-Advance Service Center.
(7): Every year, if the machine is not frequently used.
(8): If a lower-quality oil is used, change it every 125 hours.
HOPPER CLEANING
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing cleaning procedures using
compressed air or water gun.
Empty the hopper (2, Fig. F), drive the machine to the appointed cleaning/washing area, then perform the following procedure:
Engage the parking brake (21, Fig. B-C).
Lift the hopper (2, Fig. F), according to the procedure shown in the relevant paragraph.
Open the skirt (19, Fig. F).
Install the support rods (4, Fig. F).
Clean the hopper with pressurized water.
CAUTION!
With pressurized water clean the skirt and the lower part of the hopper only, to avoid dampening the closed
pocket fi lter (26, Fig. E).
1.
2.
3.
4.
5.