3 quad dock operation, 1 charging the ikôn battery, 2 connecting to the ethernet network – PYLE Audio IKON RUGGED 7505-BT User Manual
Page 274: Quad dock operation
Chapter 7: Peripheral Devices & Accessories
Quad Dock Operation
260
Ikôn Rugged PDA (Windows Mobile 6.1) User Manual
7.6.3
Quad Dock Operation
7.6.3.1 Charging The Ikôn Battery
•
Insert the DC power MINI FIT JR plug into the CH4004 rear DC input receptacle. The
adaptor LED should be ON when powered from the mains.
The CH4004 supplies DC power to enable the Ikôn internal fast charger. Normally, a full
charge of the 5000 mAh Ikôn battery will take from 2.5 to 3.0 hours.
•
Insert up to four Ikôns into the docking station charge wells, pressing down gently but
firmly to seat them securely.
•
During the charge, the Ikôn LED slow flashes green.
•
When the battery capacity reaches 95%, the LED turns solid green.
7.6.3.2 Connecting To The Ethernet Network
The rear-mounted RJ45 connector incorporates LEDs that indicate data traffic (see
Figure 7.6) when:
•
The Ikôn is in the docking station and powered on;
•
The docking station is powered by the AC adaptor;
•
The docking station is connected to Ethernet network with a Category 5 cable plugged
into the RJ45 rear socket.
The green Link LED flashes to indicate the presence of data traffic. The yellow Speed LED
is steady ON when the network is 100 Mbps and OFF when the network is 10 Mbps.
Note: Battery charging continues whether the Ikôn is switched on or off.