Battery-low indicator, Multiple-led charge indicator, Using the appliance – Philips ellite e9000 User Manual
Page 6: Useful tips, Brushing technique
1
Make sure the bottom of the handle sits back securely in the charger
so that it makes complete contact.
The handles of other Sonicare models do not fit in this charger and will
therefore not charge effectively. Do not attempt to force a handle into
this charger, as this causes damage.
Battery-low indicator
When the battery runs low, you hear 3 beeps after the Smartimer
has switched off the toothbrush. In addition, the bottom LED flashes
yellow for 30 seconds.
When you see and hear the battery-low indication, 3 or fewer 2-minute
brushings remain.
Keep the Sonicare in the plugged-in charger when not in use to maintain a
full battery charge.
Multiple-LED charge indicator
When you place the handle in the charger, the green charge indicator
LEDs flash in a rising pattern as the battery charges. The number
of flashing LEDs indicates the level to which the battery has been
charged.
When the battery is fully charged, the LEDs stop flashing and start burning
continuously. About once a minute, the charge indicator LEDs go out
briefly and then go on again. This indicates that the battery is maintained
at full charge. The full-charge indication persists until you remove the
handle from the charger.
using the appliance
useful tips
The brush head comes with a convenient travel cap. Remove the travel
cap from the brush head before you switch on the Sonicare.
Rinse the brush head and bristles after each use.
Clean the brush head weekly, including under the nut.
A fully charged Sonicare allows you to brush your teeth for 2 minutes
twice a day for approximately 2 weeks without charging. This makes it
easy to travel without the charger.
Voltage converters and plug adapters DO NOT guarantee voltage
compatibility. Always check for voltage compatibility.
-
,
,
-
-
-
-
-
EngliSh
6