Pioneer CNSD-110FM - Manual (Page 31)

Problems in the procedures for updating
Symptom Cause Action
The upgrade process doesn
’t
start and the navigation system
boots up as usual.
An incorrect SD memory card has
been inserted. Eject the inserted SD memory card and insert
the correct upgrade SD memory card.
Upgrade has been already done. Check whether the upgrade was done prop-
erly. If the upgrade has not been done yet,
consult the nearest authorized service sta-
tion.
The screen that cannot begin the
upgrade process is displayed. Eject the upgrade SD memory card #1, and
display the map of your current position, and
then reinsert the upgrade SD memory card
#1.
The navigation system does not
work properly after upgrade. The engine of your vehicle was
stopped or the power supply to the
navigation system was turned off
during upgrade process. Consult the nearest authorized service sta-
tion.
Upgrade SD memory card was
pulled out during upgrade process. Consult the nearest authorized service sta-
tion.
Messages in the procedures for updating
The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Message When What to do
An error occurred and the up-
date failed. Unexpected error occurred in the
update process. Consult your local Pioneer dealer if this mes-
sage persist.
En
31
Appendix
Tr
oubleshooting
Troubleshooting