Precor Multi-Hip Option S3.15 - Manual (Page 9)

S3.15 Multi-Hip Option Assembly Instructions
page 9
1 2 3 4 5 6
3. Install the Multi-Hip Cable
A. Feed the tab end of the Multi-Hip Cable 130194
between the two 3½-inch pulleys on the Multi-Hip
Upright and attach the cable to the Selector Hub
using
one shaft
two e-clips
B. Remove the lower 3 ¹⁄₂-inch pulley on the Multi-Hip
Upright. Feed the cable around it and reattach it
using
one 4-inch hex head bolt
two shoulder spacers
one locknut
C. Remove the 3 ¹⁄₂-inch pulley from its pulley bracket.
Feed the cable around it and reattach it using
one 2¼-inch hex head bolt
two flat washers
one locknut
D. Wrench tighten all pulley fasteners.
Step 3. Install the Multi-Hip Cable
Multi-Hip
Upright
Selector Hub
A
1 - shaft
2 - e-clips
B
1 - 2¼" bolt
2 - washers
1 - locknut
C
1 - 4" bolt
2 - 1" shoulder spacers
1 - locknut
3½-inch Pulley (used on gray
painted parts)
1 - bolt
2 - shoulder spacers
1 - locknut
Pulley assemblies
3½-inch Pulley (used on
titanium parts)
1 - zinc bolt
2 - zinc washers
1 - zinc locknut