Main unit, Using remote control, Getting started – Panasonic DMP-BD10A User Manual
Page 7

7
RQT8997
!
POWER button (Í/I POWER)(➡ 12)
Press to switch the unit from on to standby mode or vice versa. In
standby mode, the unit is still consuming a small amount of
power.
@
Disc tray (➡ 12)
#
Display
$
IIlumination lamp
Lights when the unit is turned on.
%
Open/close disc tray (➡ 12)
^
Search / Skip
Search: Press and hold
Skip: Press
&
Stop (➡ 12)
*
Pause (➡ 12)
(
Start play (➡ 12)
Rear panel terminals (➡ 8–10)
Batteries
Insert so the poles (i and j) match those in the remote control.
When closing the lid, insert it from the j (minus) side.
≥Do not use rechargeable type batteries.
≥Do not mix old and new batteries.
≥Do not use different types at the same time.
≥Do not heat or expose to flame.
≥Do not take apart or short circuit.
≥Do not attempt to recharge alkaline or manganese batteries.
≥Do not use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
Remove batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
Use
If you cannot operate the unit or television using the remote control
after changing the batteries, please re-enter the codes (➡ 11).
Main unit
OPEN/CLOSE
POWER
.
POWER
OPEN/CLOSE
Using remote control
R6/LR6, AA
30
20
30
20
Remote control signal sensor
7 m (23 feet) directly in
front of the unit
Getting started
11 Control reference guide
Gettin
g
star
ted
DMP-BD10PP_Book1.book Page 7 Friday, April 6, 2007 7:06 PM