The lcd display, End of cycle – LG DLEX3001W User Manual

Page 29

FLOW SENSE™ DUCT BLOCkAGE
SENSING SYSTEm INDICATOR

The FLOW SENSE™ duct blockage sensing
system detects and alerts you to blockages

in the ductwork that reduce exhaust flow

from the dryer. This improves operating

efficiency and helps minimize service calls,

saving you money.

THE LCD DISPLAY

(cont.)

THE DUCTWORK HAS

A BLOCKAGE THAT NEEDS

TO BE REMOVED

IMMEDIATELY.

NEED FLOW CHECK

If no bars are shown in the

display, the ductwork is free from

blockages.

If two bars in the display are

lighted, examine the dryer

exhaust system for lint build up

or other restrictions, including

damage, excess length, foreign

objects, etc. See note below.

If all bars are lit, the dryer

ductwork has a blockage

that needs to be removed

immediately.

END OF CYCLE

• 2 bars are displayed In the LCD screen.

• Ductwork is slightly too long or has too

many turns/restrictions.

• Partial blockage of the ductwork due to lint

buildup.

1. Possible causes

• Install a shorter or straighter duct run. See

the Installation Instructions.

• Ductwork should be checked/cleaned soon.

Dryer can be used in this condition, but

drying times may be longer.

• If “END OF CYCLE” is displayed after the

end of cycle, it will be off in 4 minutes. If

POWER button is pressed or the door is

opened, power will be off immediately.

2. Solutions

NOTE: If the duct has been checked and

cleaned and two bars are still displayed after

several cycles, then there is some restriction

in the duct due to length, condition, etc. In

this case, no further action is necessary and

the dryer can be used normally. However,

drying times may be increased and there may

be some reduction in operating efficiency

• 4 bars are displayed In the LCD screen.

• Ductwork is too long or has too many turns/

restrictions.

• Significant blockage of the ductwork due to

lint buildup or debris.