Shindaiwa 35701 - Manual (Page 12)

12
ASSEMBLY
35708
57704
Brake lever
support arm
4. Remove the
packing spacer.
5. Install the
guide bar.
6. Install the chain loop over the drive
sprocket, and then align the chain
drive links within the guide bar
groove. Make sure the cutters are
properly oriented.
WARNING!
Never start the engine
without the clutch cover
installed!
35709
6. Install the
chain loop.
CHN-14
BAR
TIP
Top of Bar
Bottom of Bar
Tensioner Pin
7. Install the clutch cover over the two
bar studs, and then engage the
brake lever and support arm. Install
the two 13 mm bar nuts and tighten
finger-tight only.
CAUTION!
Failure to align the guide bar and
chain tensioner pin as shown can
cause serious damage to the
clutch cover, guide bar, tensioner
pin and/or engine crankcase!
Installing and Adjusting the Guide Bar and Saw Chain
29
Spark Arrester
Hard starting or a gradual loss of
performance can be caused by carbon
deposits lodged in the spark arrester
screen. For maximum performance,
the spark arrester screen should be
periodically cleaned as follows:
1. Unscrew the two clutch cover nuts,
and remove the clutch cover (see
page 11).
2. Use a screwdriver to remove the
two spark arrester retaining
screws, and then remove the spark
arrester cover and screen.
3. Use a plastic scraper or wire brush
to remove carbon deposits from the
arrester screen and cover.
4. Inspect the screen carefully, and
replace any screen that has been
perforated, distorted, or is other-
wise unserviceable.
5. Install the screen and cover in the
reverse order of disassembly, and
then tighten the two cover retaining
screws securely.
6. Install the clutch cover and cover
retaining nuts in the reverse order
of removal, and then tighten both
nuts securely.
35722
Engine
Muffler
Spark
Arrester
Cover
Spark Arrester
Screen
Long Term Storage
■ Thoroughly clean the saw exterior.
■ Remove all chips and other debris
from the cylinder fins and cooling
passages.
■ Drain the fuel tank, and then clear
the carburetor and lines by running
the saw until it stops from lack of
fuel.
CAUTION!
Never store the saw with any fuel
remaining in the tank, fuel lines, or
carburetor!
Your Shindaiwa warranty does not
include coverage for damage caused
by “stale” or contaminated fuels!
■ Drain any remaining bar oil from
the oil reservoir.
■ Remove the spark plug, and then
pour about 1/4-oz of 2 cycle mixing
oil into the cylinder through the
spark plug hole. Before reinstalling
the spark plug, slowly pull the recoil
starter 2 or 3 times to distribute the
oil over the cylinder walls.
■ Remove, clean, and reinstall the air
filter element as described under
“Daily Maintenance’’.
■ Repair or replace any damaged
components as required, and then
store the machine in a clean, dry,
dust-free area.
MAINTENANCE
(over 30 days)