beautypg.com

Vacation time, Light bulb replacement – Sub-Zero 200 Series User Manual

Page 9

background image

9

Vacation Time

Model 245

To replace the refrigerator light

bulb (25 watt), remove upper

shelf and pull control knob off.

Grip refrigerator control diffuser

firmly on top and bottom and

snap out of position. The light

bulb is now accessible.

To replace the freezer light bulb

(25 watt), pull control knob off.

Grip freezer control diffuser

firmly on top and bottom and

snap out of position. The bulb is

now accessible.

To reinstall, reverse procedure.

Model 249R

The light bulb (25 watt) is

located beneath the freezer

evaporator and is accessed by

reaching up underneath behind

the right hand side of the freezer

section. Unscrew and replace.

Model 249RP

The light bulb (25 watt) is

accessible by removing three

screws which anchor the light

bracket. Remove bracket and

reach behind the light diffuser

and unscrew bulb.

To reinstall, reverse procedure.

Model 249FF

The light bulb (25 watt) is

mounted behind the left side of

the blower fan assembly at the

top of the back wall of the

freezer. Unscrew and replace.

For short vacations: Remove all

perishable items. Shut off the

icemaker. See Icemaker

Operation on page 7. Do not

change the settings of your

controls.

For extended vacations: The

control(s) to your refrigerator or

freezer should be shut off.

Empty all contents in the

refrigerator/freezer and wash,

rinse and dry interior of unit.

Vacant homes: If for any reason

this unit is put into service on a

temporary basis and later shut

off, the control(s) to the

refrigerator or freezer should be

shut off.

For extended vacations or vacant

homes, you should block door(s)

open slightly. About one inch, so

fresh air can circulate and keep

interior dry. You should also

turn off power to the unit or

loosen light bulb(s).

CAUTION

Always shut off the circuit

breaker to the unit and

wear protective gloves

when replacing light bulbs.

Light Bulb
Replacement

CAUTION

The moisture developed

during even the shortest

amount of running time

could attack the metal parts

if the doors are left closed

after shutting down. Be

sure the doors are blocked

open after any operation.

200 Use & Care Guide 3758377 1-04.qxd 1/2/2004 1:04 PM Page 9