Woodstock SHOP FOX W1754 - Manual (Page 34)

-32-
W1754 20" Planer With Mobile Base
SE
RV
IC
E
7. Adjust the height of the infeed roller on the same
side as the Rotacator to the specification given at
the beginning of this procedure, using the zero set-
ting of the Rotacator as a reference point. Figure 30
shows the jam nut and set screw for adjusting the
roller height.
8. Repeat Steps 6–7 on the left-hand side of the infeed
roller.
9. Double-check and micro-adjust both sides of the
infeed roller, then carefully lock both sides in place.
10. Using the same zeroed reference on the Rotacator,
adjust the height of the outfeed roller, pressure bar,
and chip breaker to their given specifications. The
adjustment controls for each are shown in Figures
30-32.
Figure 30. Typical roller height
adjustment controls.
Figure 31. Typical pressure bar height
adjustment controls (One side shown. Bar
not in sight.)
Figure 32. Typical chip breaker height
adjustment controls (One side shown).
Jam
Nuts
Set
Screw
Adjustment
Location
Adjustment
Location
OFF
OFF
OFF
Outfeed
Roller
Set
Screw
Chip Breaker
Pressure Bar
Bracket
Infeed
Roller