Woodstock SHOP FOX W1754 - Manual (Page 14)

-12-
W1754 20" Planer With Mobile Base
SE
T
U
P
To attach the table extension wings, do these steps:
1. Install the M8-1.25 x 20 set screws in the holes in
the bottom of the wings ( Figure 5).
2. With the help of an assistant, attach the table
extension wings to the planer table ( Figure 5) with
the M8-1.25 x 35 hex bolts. Finger tighten the bolts
for now.
3. Check table-to-extension wing alignment (Figure
6) with a straightedge and adjust the leveling set
screws until the table and wings are flush.
4. Tighten the hex bolts.
Figure 5. Extension wing fasteners and
leveling controls.
Figure 6. Example of leveling extension
wings and table.
Extension Wings
Extension wings are heavy and could cause per-
sonal injury if dropped during installation. Have an
assistant hold the table while you fasten it to the
planer.
Set Screws
Hex Bolts