Woodstock 17" Drill Press W1680 - Manual (Page 19)

-18-
Table Adjustments
The table can be adjusted for height, rotation
and angle. Follow these instructions to adjust
height:
1. Loosen the support bracket lock knob. Turn
the table hand crank to lift or lower the
table. Figure 28.
2. Always lock the support bracket in place
before operating machine.
Adjust rotation:
1. Loosen the lock handle located under the
table. See Figure 29. Rotate table the
desired amount.
2. Always lock the support bracket in place
before operating machine.
Adjust angle:
1. Turn the nut indicated by the arrow in
Figure 30, in a clockwise direction. This
will draw the location pin out of the casting.
Once loose, pull pin and nut out and set it
in a safe place until needed.
2. Loosen large bolt in the center of the sup-
port bracket.
3. Rotate the bracket to the desired angle. Use
the scale on the side of the bracket or pro-
tractor to set angle. Lock in place by tight-
ening bolt.
When repositioning table to 0˚ position, loosen
the large bolt in the center of the support cast-
ing. Rotate the support casting until the degree
scale reads 0˚. Carefully tap the location pin
back into the hole from which it came until it
stops. Unscrew the nut on the location pin until
the it is flush with the end of the threads. This
will protect the threads when you tap it into
place with a hammer. Turn the nut clockwise
until it is snug against the casting and then
tighten the large bolt in the center. The table is
now set to the factory pre-set angle.
Figure 28. Changing table height with crank.
Figure 29. Unlock table for rotation.
Figure 30. Locating pin and nut.
ADJUSTMENTS