Woodstock 17" Drill Press W1680 - Manual (Page 12)

-11-
Figure 12. Bottom of rack in position.
Figure 13. Inside bevel in the correct position.
Table Support, Cont.
4. Slide the table support bracket onto the col-
umn while holding the rack in place. Allow
the bracket to go down until the bottom of
the rack contacts the shoulder on the col-
umn support. Figure 12. Secure the table
with the lock handle.
5. Slide the column ring onto the column with the
inside bevel in the down position. Figure 13.
Adjust the ring until the tip of the rack fits
inside the bevel. Tighten the setscrew on the
ring.
NOTICE
Use caution when tightening set screw. Over tight-
ening will split column ring.
ASSEMBLY