Woodstock SHOP FOX M1102 - Manual (Page 28)

-26-
M1102/M1103 16-Speed Drill Press
M
A
IN
TE
N
A
N
CE V-Belts
Inspect regularly for tension and wear. Check
pulleys to ensure that they are properly
aligned.
Since all bearings are shielded and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
For other items on this machine, such as the
quill, table and column, horizontal and verti-
cal columns, an occasional application of light
machine oil is all that is necessary to maintain
smooth rust-free operation.
Before applying any lubricant, clean off the old
lubricant, and any sawdust or metal chips.
DO NOT over lubricate, your goal is to achieve
adequate lubrication. Too much lubrication will
attract dirt and sawdust, and various parts of
your machine could loose freedom of move-
ment.
Periodic maintenance on your Model M1102 and
M1103 Drill Press will ensure its optimum per-
formance. Make a habit of inspecting your drill
press before each use.
Check for the following conditions and repair
or replace when necessary.
1. Loose or missing base mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged drive belt.
5. Loose chuck or arbor.
6. Any other condition that could hamper the
safe operation of this machine.
Tables can be kept rust-free with regular appli-
cations of oil or anti-rust products.
NEVER adjust or service
the machine while it is
running. Wait until the
machine is turned off,
unplugged and all working
parts have come to a stop
before proceeding!
Table and Base
Lubrication
General
MAINTENANCE