Woodstock SHOP FOX M1102 - Manual (Page 19)

-17-
M1102/M1103 16-Speed Drill Press
SE
T
U
P
Figure 15. Downfeed handles and belt
cover knob installed.
The downfeed handles must be installed to properly oper-
ate the drill press.
To install the downfeed handles, do these steps:
1. Thread the knobs onto the handles, then thread the
handles into the spindle hub, as shown in Figure 15,
and tighten.
2. Install the belt cover knob in its place (see Figure 15
for location).
Downfeed Handles & Belt
Cover Knob
Spindle Hub
The table must be installed to properly support the
workpiece during operation.
To install the table, do these steps:
1. Insert the table shaft into the table support assem-
bly.
2. Tighten the small locking lever (Figure 16) to secure
the table in the table support assembly.
Table
Figure 16. Table installed.
Belt Cover
Knob