Woodstock SHOP FOX M1102 - Manual (Page 18)

-16-
M1102/M1103 16-Speed Drill Press
SE
T
U
P
Figure 13. Seating arbor into chuck.
DO NOT use a steel hammer on the
drill chuck to seat the arbor into the
spindle. You will damage the chuck
and/or spindle, which may make them
unusable or unsafe.
Figure 14. Seating arbor and chuck into
spindle.
4. Place the drill chuck face down on a workbench. The
arbor has a short taper and a long taper. Place the
short taper into the socket in the back of the drill
chuck and tap it with a rubber or wooden mallet,
as shown in Figure 13. If the chuck fails to remain
secure on the arbor, repeat Steps 1 & 2.
5. Raise the chuck guard.
6. Slide the arbor into the spindle socket while slowly
rotating the drill chuck. The socket has a rectangular
pocket where the tang (or flat portion of the arbor
shown in Figure 13) fits into.
7. Using only a rubber or wooden mallet, tap the chuck
and arbor assembly into the quill as shown in Figure
14. DO NOT use a steel hammer.