C. front clamp will not adjust – Woodstock Shop Fox Fence W1410 User Manual

Page 22

Shop Fox

Fence

-21-

C. FRONT CLAMP WILL NOT

ADJUST

If the cap screws (#37) that hold the front carriage

(#30) to the fence are not tight enough, the car-

riage may shift slightly when locked, thus releas-

ing pressure on the front clamp.

Step 1.

Reference Figure 31 to verify the position of the

front carriage relative to the front of the fence.

Note: To properly tighten the cap screws (#37),

insert the long leg of the 5mm Allen wrench into

the hex socket of the cap screw and apply torque

to the short leg of the Allen wrench using an

adjustable open end wrench.

Step 2.

If the front clamp cannot be adjusted tight enough

with the front carriage in its standard position,

shift the carriage forward

⁄

" so that the front

dimension in Figure 30 becomes

⁄

" and work

through the adjustment procedure again.

Figure 31. Front carriage positioning.

Figure 30. Distance between carriages.

Step 7.

Before tightening the carriages against the under-

side of the fence, use Figure 30 to get them posi-

tioned correctly. The distance ''Y'' between the

front and rear carriage should equal the distance

between fence rails + 1

⁄

''.

Step 8.

Once reassembled, proceed to work through

Section III, Part D & E to get the front and rear

clamps adjusted properly.

Figure 29. Correct orientation of the yokes.

Front carriage

Front

Rear