Sony ICD VGN-UX200 - Manual (Page 142)

142 n N
Troubleshooting
What should I do if a BIOS error appears when I turn on my computer?
If the message "Press to resume, to setup" appears at the bottom of your computer screen, follow these steps:
1 Press and hold the Fn key and press the F2 key.
The BIOS setup screen appears.
2 Set the date (month/day/year). Press the Enter key.
3 Press the m key to select System Time, and then set the time (hour: minute: second). Press the Enter key.
4 Press the , key to select the Exit tab, and then press and hold the Fn key and press the F9 key.
The message Load default configuration now? appears.
5 Select Yes, and press the Enter key.
6 Select Exit (Save Changes) or Exit Setup, and press the Enter key.
The message Save configuration changes and exit now? appears.
7 Select Yes, and press the Enter key.
Your computer restarts.
If this occurs frequently, contact an authorized Sony Service Center. To find the nearest center or agent, visit the Sony online
support Web site.
What should I do if the power indicator (Green) lights but my computer screen stays
blank?
Follow these steps:
1 Slide up (in the direction of f on the switch) and hold the power switch for more than four seconds to check that the power
indicator goes out. Then turn on your computer again.
2 If your computer screen still stays blank, unplug the AC adapter, remove the battery pack, and leave the computer for
about a minute. Then plug in the AC adapter, install the battery pack, and turn on the computer again.