Jacuzzi J - 470 - Manual (Page 95)

Page 89
J-400 Series
19.8 Generic mP3 Player Operation
1. Connecting Your mP3 Player
A. Plug in any MP3 player’s
headphone output jack
with supplied cable into the
auxiliary port (11) using the
supplied audio RCA cable.
Close stereo compartment
during use to prevent
moisture from entering the
compartment.
2. setting up The mP3
Player for use
A. Select preferred song/album/
playlist prior to plugging in
MP3 player and start playback.
B. Press “Mode Button” on stereo receiver until the LCD display
reads “auX”.
note: All external MP3 player playback operations are performed solely
by the MP3 Player with the exception of volume control and “Mode
Button” selector, which can be controlled via wireless remote or on the
stereo receiver.
warnInG: rIsK OF eleCTrICal sHOCK HaZarD
eXIsTs anD eQuIPmenT DamaGe! Never connect, dis-
connect or operate external MP3 player while hands are wet
or while sitting or standing partially or fully immersed in water!
19.9 J-1000 audio system stereo Troubleshooting
1. unit will not turn-on
Make sure spa power is turned on, then
check both harness fuses on side of unit
making sure they are the proper ratings:
Yellow memory B+ line (10A fuse). •
When faced with a malfunction during •
operation, push BND button (8) and Eject
button (13) at the same time to reset
software.
With spa power off, use a paperclip to •
press the reset button located besides the USB Docking Station (10)
to do a hardware reset.
note: It will be necessary to re-enter the radio preset memories and
other personal settings after performing a reset. After resetting player,
always ensure all functions are operation correctly.
1
2 17 3
9 8
7 5
4 6
10
11
13
15
12
16
14
18
USB