JVC HD-Z56RX5 - Manual (Page 6)

LT-Z70/56RX5 / LCT1911-001A / English
5
ENGLISH
Setting up your TV
Installation
Cautions for installation
• Install the TV in a corner, against a wall or on the floor so as to
keep cords out of the way.
• The TV will generate a slight amount of heat during operation.
Ensure that sufficient space is available around the TV to allow
satisfactory cooling. See “Installation requirements” on page 3.
Connecting the aerial and video
cassette recorder (VCR)
• Aerial cable is not supplied. Use a good quality 75-ohm coaxial
cable.
• Read the manual that came with the VCR before connecting.
„ When connecting the aerial without a VCR:
„ When connecting the aerial with a VCR:
To connect a video and audio cable to a VCR
Note that the connection with a video cable will be ignored in case
you connect a VCR to the TV with both video cable and S-VIDEO
cable.
• To connect additional external devices, please see “Additional
preparation” on page 24.
Connecting the power cord to the AC
outlet
Insert the AC plug on the power cord from the TV into AC outlet.
• Remove the AC plug from the outlet to completely disconnect the
TV from the power supply.
Putting the batteries into the remote
control
Use two AA/R6 dry cell batteries.
Insert the batteries from the - end, making sure the + and -
polarities are correct.
• The batteries we supply are only for setting up and testing your
TV, please replace them as soon as you need to.
Turning the TV on
Press the POWER button on the TV or # (standby) button
on the remote control.
When the POWER button is pressed, the POWER LED lights up and
the LAMP LED indicator blinks in orange for approximately 1
minute at approximately every 2 seconds.
As the picture becomes brighter, the LAMP LED goes out.
• Immediately after the power is turned on, the picture is displayed
only dimly on the screen.
• It is impossible to turn the power off during this period. After 1 or
more minutes have passed, you can turn off the power.
• When the TV is first turned on, it goes into the initial settings
mode (see “Initial settings (Setup tour)” on page 6).
Caution
• Turn off all the equipment including the TV before
connecting anything.
75
(VHF/UHF)
CENSED UNDER THE
OLLOWING U.S. PATENTS
183,091
419,362
PC IN
D-SUB)
75
(VHF/UHF)
CENSED UNDER THE
OLLOWING U.S. PATENTS
183,091
419,362
PC IN
D-SUB)
Y
P B /C B
P R /C R
S-VIDEO
IN (VIDEO-2) IN (VIDEO-1)
VIDEO
L
I
AUDIO
I
R
L
I AUDIO
I
R
VIDEO
OVER OVER
S-VIDEO
Caution
• Operate only from the power source specified (AC 110 –
240 V, 50/60 Hz) on the unit.
POWER button LAMP LED POWER LED
LAMP/PROGRAM POWER
LAMP
POWER
LAMP/PROGRAM POWER
LAMP
POWER
HD-Z70&56RX5_Eng.book Page 5 Wednesday, August 24, 2005 10:30 AM