Philips Magnavox NB500MG9 - Manual (Page 12)

12 EN
CONNECTIONS
Connection to the TV
Make one of the following connections, depending on the capabilities of your existing device.
COMPONENT
VIDEO OUT
P B /C B
P R /C R Y
COMPONENT
VIDEO IN
Y
P B /C B
P R /C R
AUDIO IN
L R
VIDEO
OUT
VIDEO
IN HDMI IN
DVI IN
and or or or
* 1, 2
TV
this unit
standard audio
RCA
audio cable
AUDIO CONNECTION AUDIO / VIDEO
CONNECTION
HDMI
cable
best audio / picture
Method 4
VIDEO CONNECTION
RCA
video
cable
Method 1
standard picture
HDMI-DVI
cable
Method 3 *
1
best picture
RCA
component
video cable
better picture
AUDIO OUT HDMI OUT VIDEO OUT COMPONENT
VIDEO OUT
Method 2 *
1
(Red)
(Blue)
(Green)
(Red)
(Blue)
(Green)
* 1 This unit is compatible with the progressive scan system. The feature provides you with the higher quality pictures
than traditional output system does. To utilize this feature, a component or an HDMI connection is required. Refer
to “HDMI Video Resolution” or “Component Output” setting on page 34 to set the video resolution.
* 2 Analog audio connection is not required for this connection.
Supplied cables used in this connection are as follows:
RCA audio cable (L/R) x 1
RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
•
•
Note
Connect this unit directly to the TV. If the RCA audio / video cables are connected to a VCR, pictures may be
distorted due to the copy-protection system.
If the picture is not output properly to the TV because of “HDMI Video Resolution” or “Component Output” setting,
press and hold [ B PLAY] on the front panel for more than 5 seconds. “HDMI Video Resolution” and “Component
Output” setting will be reset to the default automatically.
A simple 1-cable connection with a device having an HDMI (high-definition multimedia interface) jack allows
digital transfer of both digital video signals and multi-channel audio signals. •
•
•
•
E5E20UD_E5H20UD-NB500MG9_EN.indd12 12 E5E20UD_E5H20UD-NB500MG9_EN.indd12 12 2008/02/25 9:30:28 2008/02/25 9:30:28