Philips Magnavox 13MT143S - Manual (Page 7)

7
Ω
Ω
T he basic Antenna/Cable TV to Accessory
(VCR, DVD Player, etc.) to TV connection is
shown at right. For other hookups (such as
those with Cable Boxes), refer to the owner’s
manual of the Cable Box or other Accessories.
1 Connect your Antenna or Cable TV
signal to the IN (from Antenna or
Antenna In) jack on the Accessory.
2 Use an RF coaxial cable to connect
the OUT (to TV or Antenna Out)
jack on the Accessory to the 75
Ω
jack on the TV. The necessary cables
may be supplied with the Accessory, but
are not supplied with the TV.
3 For VCR use, set the TV to channel 3
or 4 (same as the VCR’s Channel 3/4
switch).
To watch TV, change TV channels at the
VCR. Or, turn off the VCR and change
channels at the TV as usual.
Basic TV to VCR (Accessory) Connection
RF coaxial cable
(75
Ω
)
Cable TV signal
or antenna
Rear of TV
ANTENNA OUT
ANTENNA IN
VIDEO AUDIO
IN IN
OUT OUT
– VOLUME + CHANNEL
MENU
– VOLUME + VOLUME +
MENU MENU
POWER
CHANNEL CHANNEL POWER POWER
AUDIO VIDEO
AUDIO AUDIO VIDEO VIDEO
There are Audio and Video In jacks on the front
of the TV. You can connect a Camcorder,VCR,
or other accessory to these jacks, then watch
the video from that equipment on the TV.
Set the TV to the AV channel. (Go to your low-
est TV channel, then change channels down to
see the AV channel.)
Audio/Video In jacks
Yellow (video) and
White (audio) cables
VCR, Camcorder, DVD Player, etc.
with Audio and Video Out jacks
VCR, etc.
Red and White
Audio cables
VCR, Camcorder, DVD Player, etc.
with Audio and Video Out jacks
AUDIO/VIDEO IN jacks on front of Stereo TV
(red and white AUDIO IN jacks) (20MS233S)
Yellow
Video
cable
AUDIO/VIDEO IN jacks on front of non-stereo TV
(single white AUDIO IN jack) (13MT143S and 20MT133S)
If no Video Signal is present, the TV will
display a “BLUE” screen and shut itself
off in about 5 minutes. If the TV is tuned
to the AV channel and there is no Video
Signal present, the screen will remain
black and the TV will shut itself off in
about 5 minutes.