beautypg.com

Preparation, Rear panel, Installing the batteries for the remote control – Philips Magnavox DV220MW9 User Manual

Page 9

background image

PRECAUTIONS

PREPARATION

ADVANCED PLAYBACK

BASIC OPERATIONS

RECORDING

OPTIONAL SETTINGS

TROUBLESHOOTING

INFORMATION

EN

EN

9

PREPARATION

1. DVD/VCR AUDIO OUT jack ¬p.10

Connect an RCA audio cable from here to the audio
input jack of your television or audio device. Standard
connection for DVD/VCR use.

2. VCR AUDIO IN jack ¬p.22

Connect an RCA audio cable from the audio output
jack of your camcorder, VCR, etc. to here.

3. DIGITAL AUDIO OUT COAXIAL* jack ¬p.12

Connect a digital audio coaxial cable from here
to the digital audio coaxial in jack of a decoder or
audio receiver.

4. DVD AUDIO OUT* (analog) jack ¬p.11

Connect an RCA audio cable from here to the audio
input jack of your television or audio device.

5. S-VIDEO OUT* jack ¬p.11

Connect an S-video cable from here to the S-video
input jack of your television.

6. COMPONENT VIDEO OUT* jack ¬p.11

Connect component video cables from here to the
component video input jacks of your television.

7. DVD/VCR VIDEO OUT jack ¬p.10

Connect an RCA video cable from here to the
VIDEO input jack of your television or audio device.
Standard connection for DVD/VCR use.

8. VCR VIDEO IN jack ¬p.22

Connect an RCA video cable from here to the video
output jack of your camcorder, VCR, etc.

* For enhanced DVD viewing. DVD/VCR video and audio

connection required to view cassette tapes.

Note:

RCA audio and video cables are included for
both VCR and DVD viewing. You can enhance
your DVD picture and sound quality with an
S-video cable, component video cables, or a
digital audio coaxial cable. Please purchase
the necessary cables at your local store.

(Refer to pages 11-12.)

Rear Panel

DIGITAL

AUDIO OUT

COAXIAL

AUDIO

OUT

DVD

VCR

DVD/VCR

S-VIDEO

OUT

COMPONENT

VIDEO OUT

AUDIO IN

VIDEO IN

AUDIO OUT

VIDEO OUT

L

L

Y

R

R

C

B

C

R

3

5

4

6 7 8

L1

1

2

Install the batteries (AA x 2) matching the polarity
indicated inside battery compartment of the remote
control.

Keep the following in mind when using the remote
control:

Make sure that there are no obstacles between the
remote control and the infrared sensor window on the
unit.
The maximum operable ranges of the unit are:
- Line of sight: approx. 23 feet (7m)
- Either side of center:

approx. 16 feet (5m) within 30°

- Above:

approx. 16 feet (5m) within 15°

- Below:

approx. 10 feet (3m) within 30°

16 feet (5m)

30˚

30˚

16 feet (5m)

23 feet (7m)

Caution: Never throw batteries into a fire.

Note:

Do not mix different types of batteries together
(e.g., Alkaline and Carbon-Zinc) or old batteries
with fresh ones. Although they may look similar,
different batteries may have different voltages.
If the remote control is not to be used for a long
period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
Do not try to recharge batteries; they can

overheat and rupture.
Batteries should always be disposed of with
the environment in mind. Always dispose of
batteries in accordance with applicable laws
and regulations.

Installing the Batteries for the Remote Control

E8K6SUD_DV200MW9_v1.indd 9

E8K6SUD_DV200MW9_v1.indd 9

2007/12/25 10:30:26

2007/12/25 10:30:26