Metz Astral-72 MF - Manual (Page 14)

14
7. Programming stations
You can programme the TV stations in three diffe-
rent ways.
a) Automatic station search
The automatic station search function searches the
entire range of reception frequencies for TV stations.
All stations which are found are placed in a station
table, which is displayed at the end of the search
operation. If you are not satisfied with the order in
which the stations are stored, you can shift or delete
stations (see Section 9, "Sorting stations").
Executing an automatic station search
• Press the „MENU“ key to call the TV menu
• Press the red key to open the
„Configuration“ menu.
• Use the cursor control key to select
"Automatic station search" and press
the "OK" key.
• If your TV set has the appropriate
option2), you can select the desired
TV standard with the - + key in the
setting window (in this example, the
standard B/G is selected).
• Use the cursor control key > to select
the menu item "Station search
(START)" and press the "OK" key to
confirm your selection.
• A station table containing all stations which are
found is displayed on the left side of the screen.
• At the end of the search, all stations which were
found are sorted and displayed.
• To delete any unwanted stations, select them
with the cursor and press the II key.
• To save the stations, press the "OK" key and
enter, with the numeric keys, the number of the
programme position where the first station is to
be saved. The remaining stations are saved in
the following programme positions.
Operation
Function for F3*
Function for F1*
EURO sockets*
Station search
Country*
Language*
TV standard B/G Station search (START)
Picture-Volume
AV devices
Station table
Timer
DataLogic
Terr. station search
TV
-Menü
Configuration
Call the menu
MENU
OK
: select
menu item
‚ ‚ ‚
* The number of subjects and sections
displayed here depends on the opera-
ting scope setting in the menu.
2) Available only on TV sets
which are equipped with this
option.