Fuji Bikes FRENIC 5000G11S/P11S - Manual (Page 10)

1-1
1. Before Using This Product
1-1 Receiving Inspections
Unpack and check the product as explained below.
If you have any questions about the product, contact
the nearest Fuji sales office or your local distributor
where you purchased the unit.
① Check the ratings nameplate to confirm that the
delivered product is the ordered one.
Ratings nameplate
TYPE : Inverter type
SOURCE : Power rating
OUTPUT : Output rating
MASS : Mass (not indicated for products with 30HP or less)
SER.No.
: Serial number
7 5 A 1 2 3 A 0 0 0 1 Z
Production lot serial number
Production month:1 to 9: January to September,
X: October, Y: November, Z: December
Production year: Last digit of year (7 --> 2007)
② Check for damaged and/or missing parts upon delivery.
③ In addition to the inverter unit and this manual, the package contains rubber bushing (for products with
30HP or less) and a terminating resistor (1/2 W, 120Ω). The terminating resistors for products with
30HP or less is packed in a sack. The terminating resistors for products with 40HP or more is
connected to the control terminal of the inverter unit. This terminating resistor is required for RS-485
communication. The terminating resistor need not be removed regardless of RS-485 communication
status.
1-2 Appearance
FRN 030 G11S-4 UX Power supply voltage system
:2→ 230V grade、4→460V grade
Series name:G11S or P11S
Nominal applied motor:030→30HP
Product type: FRENIC5000
30HP or less 40HP or more
Surface cover
Keypad panel
Mounting screws of surface cover
Intermediate cover
Ratings nameplate
Mounting screws of
surface cover
(6 screws total)
Keypad panel
Surface cover
Ratings nameplate
Lifting holes
(4 holes total)