Meridian Audio 501 - Manual (Page 42)

Setting up the Control Unit
38
● Turn off the control unit, using the power switch on the back
panel.
● Turn on the power again while holding down the Off key on
the front panel.
The display will show
the current Type setting:
Ty 1
● Press
A or V on the front panel to change the Type setting.
If your system includes a Meridian CD player select Type 2;
otherwise select Type 6.
For example, if you select
Type 2 the display will show:
Ty 2
● Switch the power off and on again to restore the control unit
to normal operation.
● To return to 500 COMMS operation repeat the above
procedure, and select Type 1, 3, 4, or 5. For more information
see Choosing standard settings, page 20.
To connect to a 555 Stereo Power
Amplifier
Main Out
501 Control Unit 555 Stereo Power Amplifier
Audio lead
INPUT INPUT
L
R
● Connect one pair of the sockets marked Main Out L and R on
the rear panel of the 501/501V Control Unit to the INPUT
sockets on the rear panel of the 555 Stereo Power Amplifier.
To connect to Meridian 600 or 200
Series equipment
If your system includes any Meridian 600 or 200 Series units,
with 600 COMMS or 200 COMMS sockets, you should set all
the 500 Series units to 200 COMMS operation using the
following procedure: