Bernina 532-2 - Manual (Page 51)

^di^аа^^аИККа
Embroidering around holes
The complete equipment for embroidering around holes, which is not part of the stan­
dard accessories, comprises the following components :
53 06 62 Hole embroidery foot
63 OG GO Needle plate complete with slide for holes
54 12 01-01 Embroidery ring
64 11 05 Square piercer
64 11 06 Hound piercer
This simple device permits sewing fashionable " Broderie Anglais " and circular em­
broideries on the Bernina-Record and 632, It allows sewing around holes of various
sizes and making circular embroideries up to approximately 1 inch in diameter. In
both cases the stitch width may be varied during the operation of sewing around.
For bole embroidering set the machine as follows ;
1. set needle to left position by turning lever 13 (Pig.2) to the left:
2. lower feed dog by turning control lever IT (Fig. 2) to the left for darning symbol;
3. replace ordinary needle plate with hole embroidery needle plate complete with slide,
attach hole embroidery presser foot.
Ü6
Always use the em­
broidery
frame. We
recommend winding
strips of cloth around
its outer ring to obtain
better tension of the
material and to pre­
vent damage to it. On­
ly after clamping the
material in such man­
ner, punch the holes
with the piercers sup­
plied. It is of advan­
tage to previously ma rk
the holes on the mate­
rial hy means of a
pencil or the like.Then
place the material un­
der the hole embroi­
dery foot so that the
guide pin of the slide
projects through the
hole. As mentioned be­
fore, the needle is to
set in left position
(page 44, Fig. 23 b).
Position of slide for
hole embroidery
Fili. TS
Eiiibroidering is
performed in the
vaiLroictery frame
Fi*. 76
97