Xerox DocuColor 1632-5218 - Manual (Page 26)

1–20
U S E R G U I D E (C O P I E R )
Transparencies
Transparencies can only be fed from Tray 5 (Bypass). Stripeless
transparencies are recommended. Do not use white-border
transparencies.
NOTE: Use only the transparencies recommended in the
Recommended Materials for the DocuColor Series.
After loading the transparencies you can program the copier
printer to insert a blank separator page between transparencies by
using the Transparency Separators feature.
For more information about the Tranparency Separators feature,
refer to the section entitled Transparency Separators, in this
chapter.
Follow these guidelines to prevent static build up when using
transparencies:
• Place no more than twenty 8.5x11 inch or A4 transparencies in
Tray 5 (Bypass) at one time.
• Place only one 11x17 in. or A3 transparency in Tray 5
(Bypass) at a time.
• Remove the transparencies from the Center Output Tray
before running additional sets.
NOTE: Transparencies cannot be delivered to the Finisher Tray.
For more specific information about materials that have been
tested and approved for use in the DocuColor 2240/1632, refer to
the Recommended Materials for the DocuColor Series.
Information is also available off the main Xerox web site
(www.xerox.com) and will be updated periodically.