NHT Evolution System User Manual

Page 22

Step 4: Install Wire Channel Assembly

The wire channel assembly for the P5 and P6

pedestals neatly routes the speaker wire down

the back of the pedestal. It consists of two plas-

tic U shaped brackets, one plastic channel and

four 6-3/4 screws.

To install, first strip ½” -

¾” of insulation from

the ends of your speak-

er wire and connect

them to the monitor’s

binding post by loosen-

ing the binding post

nuts and slipping the

wire into the hole

behind each nut.

Tighten the nuts with

your NHT wrench.

Remember to check for

the correct polarity (see

section 5.3 and 5.3).

Slip the channel over the speaker wire. The

brackets are recessed on one side to accept the

ends of the wire channel. These recesses

should face each other when the channel is

installed. There are small pilot holes in the rear

of the pedestal to accept the 6-3/4 bracket

screws. Fasten the channel to the pedestal with

the brackets and the four screws as shown.

Step 5: Install Spikes (optional)

Spikes provide additional stability when the

pedestal is placed on thick carpet or on an

uneven surface. Position the speakers in or

close to their permanent location before

installing the spikes. It is difficult to move the

speakers once the spikes are in place.

Install the locking

nuts on the

threaded spikes

and screw them

all the way down

the shaft until

they stop. Attach

the spikes on

one side of the

pedestal at a

time. Tilt the

pedestal as

shown in the

photograph and

Channel

Bracket

Recess