Fisher & Paykel CG122 - Manual (Page 18)

16
To cooktop
UNLOCK
LOCK
LOCK
To cooktop
LOCK
Arrow
Installing the gas pressure regulator
1 Prepare the elbow connection:
First use a wrench to loosen the manifold female
pipe fitting and then turn the elbow
connection in the required direction.
Once you have the spatial arrangement required,
use a wrench to re-tighten the elbow-
manifold female pipe fitting connection.
Note: when tightening the connection, make sure
you hold it firmly in position (eg by
using adjustable pliers or an adjustable wrench)
and take care not to damage the thread.
2 Connect the extension pipe to the elbow:
Mount the extension pipe to the elbow connection,
making sure you place the supplied
washer between them.
Note: when tightening the connection, make sure
you hold it firmly in position (eg by
using adjustable pliers or an adjustable wrench)
and take care not to damage the thread.
3 Prepare the gas pressure regulator:
Mount the 3/8” NPT (conical) male connector to the
gas pressure regulator and tighten by
using a wrench.
Note: take care not to overtighten the connector, as
doing so may crack the gas pressure
regulator.
4 Connect the gas pressure regulator assembly to the
extension pipe:
Mount the gas pressure regulator assembly to the
extension pipe, making sure you place the supplied
washer between them (see Fig. 11).
Important!
Use two wrenches to tighten the connection.
Installation instructions
Fig. 8 Preparing the elbow connection
Fig. 10 Preparing the gas pressure regulator
Fig. 11 Connecting the gas pressure regulator assembly to the extension pipe
Fig. 9 Connecting the extension
pipe to the elbow
US CA